RME RMETEB Tascam Expansion Board

Manufacturer: RMESku: RMETEB
In Stock With Supplier. Please contact us for eta.
Price: NZ$598.99
Delivery: $10 per order
or $15 for Rural Delivery
RME TEB Tascam Expansion Board

The RME TEB TDIF Daughter Card for DIGI96 Series, Hammerfall and HDSP9632. Adds an 8-channel TDIF interface to all ADAT-capable RME cards.

The RME TEB adds an 8-channel TDIF interface to all ADAT-capable RME cards. Special features include manual choice of clock reference, status LEDs and a word clock output. The RME TEB is designed for maximum flexibility. Used with the Hammerfall series and the HDSP 9652, it can even be used at sample rates of 88.2 kHz and 96 kHz. Meeting the TDIF specification, Double Line mode uses two channels in single speed to get one channel in double speed. Therefore at 88.2/96 kHz 4 channels are available. Installation is done in a convenient manner using the supplied bracket. No PCI slot on the motherboard is needed. The integrated Clock Select Switch sets the TDIF reference clock, thus avoids any clocking problems even with 'problematic' TDIF devices. Used with the RME HDSP 9652, two TEBs can be connected and operated simultaneously. One TEB can be used together with either one AEBx-I or AEBx-O. Used with the Hammerfall or Hammerfall Light requires board revision 1.5 or higher, because the internal connector ADAT1Out was not implemented in earlier versions. One TEB can be connected and operated. Additionally one AEBx-O can be used simultaneously. Used with the DIGI96 Series one TEB can be connected and operated but only with those versions with an internal ADAT interface.

The main features of the RME TEB include:

  • Adds an 8-channel TDIF interface to all ADAT-capable RME cards
  • TDIF port: D-sub 25 pin
  • Supported sample rates: 44.1 kHz, 48 kHz, varispeed (33 - 57 kHz)
  • Double Line mode: 4 channels at 88.2 kHz and 96 kHz (not with DIGI96 series)
  • Word clock output: BNC, low-impedance driver stage, 4 Vss into 75 Ohms, short-circuit-proof
  • Power supply uses 3.5" floppy connector, 5 V DC, 100 mA
  • AEB needs no slot on the motherboard
  • Standard bracket, board dimensions AEB4: 75 x 95 mm
  • 2 internal cable 2-pin, 1 internal cable 3-pin, 1 power adapter cable 5 1/4 inch to 2 x 3.5 inch included

Customer Reviews

(0.00)stars out of 5
# of Ratings: 0